TS29 Shaper, 7-1/2HP 3PH 230/460V with Sliding Table

Availability: In Stock


Quick Overview

TS29 Shaper, 7-1/2HP 3PH 230/460V with Sliding Table

Please contact us for any questions you may have or to place an order!

Toll Free: 800-442-2302

Phone: 704-523-3187

Fax: 704-523-3189

Email: leneavesupp4416@bellsouth.net


The new TS29 Tilt/Slide Shaper is ready to tackle any job. A new fence design includes dual digital readouts, micrometer adjustments and independently adjustable fence halves for fast, accurate set-ups. The full guard includes two stock hold-downs and a see-through cover that flips up for quick tool changes. Dual dust collection ports, in the guard and under the table insure a clear work area and improved finish. An extra large quill assembly with a full seven inch stroke has three oversize bearings and the ability to tilt, adding versatility and insuring long, trouble-free performance. Powered by a big 7-1/2HP motor that drives the spindle forward and reverse with five speeds. The massive sliding table is fully supported by six tapered precision bearings through a full four-foot stroke. In addition, on board the table is a large miter head complete with stock hold-down clamp and a 56" miter fence with flip stop. The large table can easily accommodate a stock feeder for longer production runs.

• Sliding table with 4-foot stroke works with miter head, hold-down and fence to accomodate everything from multiple end cuts to tenons
• Fully adjustable fence with dual digital readout for fast, accurate set-up and repeatability
• Large table with built-in slider with room for stock feeder
• 7" vertical spindle travel allows stacked tooling
• Spindle tilts negative 5° to positive 45° for increased versatility
• Large diameter multiple table inserts accomodate virtually any size cutter
• Five spindle speeds in forward and reverse with lighted indicator



Style (Type) Shaper  
Spindle Speed (RPM) 3,000, 4,000, 6,000, 8,000, 10,000  
Maximum Spindle Diameter (In.) 1-1/4  
Spindle Size Under Nut (In.) 3/4 (3-1/2), 1 (6-1/4), 1-1/4 (6-1/4)  
Spindle Travel (In.) 7  
Spindle Tilt (Deg.) 45 Forward, 5 Back  
Reversible Yes  
Router Bit Collet Included 1/4, 1/2  
Maximum Diameter Cutter Above Table (In.) 12  
Maximum Diameter Cutter Below Table (In.) 9  
Table Inserts (In.) 3: One Tilting, Two Straight  
Table Size (In.) 51-1/2 x 33-1/2  
Table Travel (In.) 49-1/4  
Sliding Table Size (In.) 11-1/4 x 51-1/4  
Fence Size (L x H) (In.) 46 x 5  
Fence Travel (Major and Minor) (In.) 5-3/8, 3-5/8  
Dust Port Outside Diameter (In.) 5  
Dust Collection Minimum CFM Required (CFM) 800  
Electrical Controls Yes  
Motor Power (HP) 7-1/2  
Motor Phase 3  
Motor Voltage (V.) 230, 460  
Prewired Voltage (V.) 230